15.1.3
Remove/Exclude a Z-Wave device
• Select
(2)
Remove/Exclude a Z-Wave Device
o If the popup window does not appear, select 15.1.12 Stop Adding or
Removing a Z-Wave device and the try again.
• Put the Z-Wave device in learn Mode. Refer to the user guide for your product on
how to do this. In many cases this just requires you to press a button on the device.
• The ISY will exclude the device (this may occur a few seconds after you put the
device into learn mode).
o The popup window will go away and the nodes for the device will be
removed from the tree.
15.1.4
Shift Primary to another Controller (Controller Shift)
• Select
(3)
Shift Primary to another Controller
o If the popup window does not appear, select 15.1.12 Stop Adding or
Removing a Z-Wave device and the try again.
Figure 244: Exclude Devices Popup
Figure 245: Device Discovery Popup
Page | 412