Remove Sfp Module - Fujitsu 1FINITY L100 User Manual

Equipment Removal

Remove SFP Module

9.2
Remove SFP Module
The following links lead to related information:
Install SFP Module
Danger: Never look into the end of a fiber-optic cable. Permanent eye damage or blindness can occur very
quickly if the laser light is present. Follow local safety precautions regarding fiber.
Danger: Never handle exposed fiber with bare hands or touch it to bare skin. Fiber fragments can enter
the skin and are difficult to detect and remove. Follow local safety precautions regarding fiber.
Caution: Unplugging a SFP module can be traffic-affecting. Make sure traffic is not dependent on the
module before removing.
Step 1
Locate the SFP module to be removed.
Step 2
Inspect the fiber connections to (if any) the module to be removed. Verify that each fiber is clearly marked or
labeled to identify the correct connection location.
Note: Fiber marking or labeling depends on local practice.
Step 3
Is each fiber clearly marked to show its corresponding connector?
If YES:
Continue with next step.
If NO:
Mark or label fibers according to local practice and continue with next step.
Step 4
Disconnect the fiber-optic cables from the module to be removed.
Caution: Do not remove the wrong fiber connections. Removing a fiber connection that is in use disrupts
service.
Step 5
Lift the release lever on the module to release it from the PIU, and slowly and carefully pull module straight out.
·
Release 19.1.1 Issue 1.1, May 2021
425
Fujitsu and Fujitsu Customer Use Only