Removing The Rear Air Grid Riser Module 1; Concluding Steps - Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual

Expansion cards and backup units
8.5.1.5

Removing the rear air grid riser module 1

Figure 168: Removing the rear air grid
Ê Remove three screws (see circles).
Ê Remove the rear air grid.
V
CAUTION!
Keep the rear air grid for future use.
Always replace rear air grids into unused installation locations to
comply with applicable EMC regulations and satisfy cooling
requirements.
8.5.1.6

Concluding steps

Ê Install the riser module 1 as described in section
1 (HL)" on page 85
"Reassembling" on page 73
Ê
Ê Connect all external cables to the expansion card(s).
"Connecting the power cord" on page 79
Ê
"Switching on the server" on page 82
Ê
Ê If applicable, "Updating RAID controller firmware" on page
Ê If applicable, "Enabling Option ROM scan" on page
"Enabling SVOM boot watchdog functionality" on page 114
Ê
"Resuming BitLocker functionality" on page 120
Ê
268 Upgrade and Maintenance Manual
"Installing the riser module
106.
107.
RX2540 M2