Cardinal Health Alaris Directions For Use Manual page 108

Primary Infusion
IV Fluid Infusion (Continued)
Volume/Duration Infusion (Continued)
NOTES: (Continued)
To view infusion Time Left during a volume/duration infusion,
CHANNEL SELECT
press
START
press soft key.
Secondary Infusion
This mode is designed to support automatic secondary
infusions ("piggybacking") in the same instrument. A
secondary infusion can be programmed as a "Basic Infusion"
or "Drug Library Infusion". When the secondary
zero, an audio tone sounds (if enabled) indicating completion
of the secondary infusion. The primary infusion resumes
automatically.
When the instrument is programmed and delivering in the
secondary mode, the primary infusion is temporarily stopped
and fluid is drawn from the secondary container. Delivery
from the primary container resumes when the fluid level in the
secondary line is level with the fluid in the primary container.
2-44
Programming
- With Guardrails
®
key. To return to previous screen,
- With Guardrails
(
Pump Module
Introduction
Suite MX Protection (Continued)
Suite MX Protection
®
)
WARNINGS
• Secondary applications require
• The secondary solution
reaches
VTBI
• The secondary
Alaris
Pump and Syringe Modules Section
FU
FU
RATE (mL/h)
RATE (mL/h)
CHANNEL
SELECT
CHANNEL
SELECT
PAUSE
PAUSE
CHANNEL
OFF
CHANNEL
OFF
RESTART
RESTART
Guardrails Fluid Setup
A
TPN
4.17
mL/h
RATE
ALL
VTBI
00 45
Time Left: h min
FU
RATE (mL/h)
CHANNEL
SELECT
PAUSE
CHANNEL
OFF
RESTART
>Press START
VOLUME
PAUSE
DURATION
FU
RATE (mL/h)
CHANNEL
SELECT
PAUSE
CHANNEL
OFF
RESTART
the use of a check valve set on
the primary line.
IV
container must be higher than
the primary solution container.
VTBI
require consideration of such
variables as factory overfill,
medication additions, etc.
Underestimating the volume
causes the remaining secondary
solution to be infused at the
primary rate; overestimating
results in the primary solution
being infused at the secondary
rate. Multiple doses from a single
container are not possible.
-- Continued on Next Page --
®
System (with v9 Model 8000) DFU
START
settings