Table of Contents
Advertisement
This Section of the DFU provides
and
) instructions and information. It is used in
8210
8220
conjunction with:
®
•
Nellcor
and Masimo
•
PC Unit Section of this DFU
•
p
Module sensor and cable Compatibility Cards
S
O
2
•
p
Module Technical Service Manual
S
O
2
•
System Maintenance software (and its instructions) for Alaris
System check-in, maintenance, and wireless configuration
The
p
Modules are indicated for continuous, noninvasive
S
O
2
monitoring of functional oxygen saturation of arterial
hemoglobin (
p
) and pulse rate measured by an
S
O
2
sensor. The
p
Modules and accessories are indicated for
S
O
2
use with adult, pediatric and neonatal patients, and for patients
who are well or poorly perfused in hospitals and hospital-type
facilities. The Model
8220 S
use during motion and no motion conditions. Only one (
p
Module can be connected to the Alaris
S
O
2
The majority of user interface programming is identical for both
p
Modules. If a procedure/information applies to a specific
S
O
2
module, the following identifiers indicate the applicable model.
Model
:
8210
(8210)
Model
:
8220
(8220)
Cables and Sensors: See "General Information" for "Cables
and Sensors" information.
Alarms and Messages: See "Troubleshooting and
Maintenance" for module-specific "Alarms and Messages".
Contraindications: The
for use as apnea monitors.
Electromagnetic Environment: See "Appendix" Section of
this DFU ("Regulations and Standards", "Compliance").
®
Alaris
System (with v9 Model 8000) DFU
SpO
Modules Section
2
Introduction
p
Module (Models
S
O
2
®
cable and sensor instructions
p
Module is also indicated for
O
2
p
Modules are contraindicated
S
O
2
®
p
S
O
2
)
1
®
System.
Getting Started
WARNING
Read all instructions, for the
Modules and PC Unit, before using
®
the Alaris
System.
CAUTION
O
nly
Getting Started
p
S
O
2
4-1
Advertisement
Chapters
Table of Contents
Troubleshooting
