General Setup And Operation; Attaching And Detaching Modules; Attaching Module(S) - Cardinal Health Alaris Directions For Use Manual

Modules can be attached to either side of the PC Unit or to
either side of another module. The process to attach or detach
is the same for either side, whether attaching/detaching
to/from a PC Unit or another module.

Attaching Module(s)

1. Position free module at a
connectors.
2. Rotate free module down against PC Unit or attached
module, until release latch snaps in place.
NOTES:
Individual hospital/facility may choose to permanently attach
modules. To remove permanently attached modules, contact
qualified service personnel.
Application of adhesive tape or other materials to the sides of
the PC Unit and modules may prevent proper latching.
®
The Alaris System is designed to operate a maximum of
infusion or monitoring modules. Modules added in excess of
are recognized by the system. The Auto-ID Module can be
4
included as a fifth module. The module(s) can be attached
in any position; however, when mounted on an
recommended that a balanced configuration be maintained.
Alaris ® System (with v9 Model 8000) DFU
PC Unit Section
Attaching and Detaching Module(s)
angle, aligning
45°

General Setup and Operation

IUI
WARNING
When properly secured/snapped, the
release latch provides a very secure
connection between modules. If not
properly latched, a module can be
dislodged during operation.
4
pole, it is
IV
IUI Connectors
45°
Release Latch
General Setup and Operation
1-3