Cardinal Health Alaris Directions For Use Manual page 379

Electromagnetic Environment (Continued)
®
Alaris System (Continued)
NOTES:
Compliance levels raised by
Performed at the minimum and maximum rated input voltage.
U is the mains voltage prior to application of the test level.
AC
T
At z and
80 MH 800 MH
These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption
and reflection from structures, objects and people.
The compliance levels in the
range z -
80 MH
equipment could cause interference if inadvertently brought into patient areas. For this reason, an
additional factor of
these frequency ranges.
Field strengths from fixed transmitters [such as base stations for radio (cellular/cordless) telephones and
mobile radios, amateur radio,
accuracy. To assess the electromagnetic environment due to fixed
site survey should be considered. If the measured field strength in the location in which the Alaris
is used exceeds the applicable
normal operation. If abnormal performance is observed, additional measures may be necessary, such as
reorienting or relocating the Alaris
Over the frequency range
The (Industrial, Scientific and Medical) bands between
ISM
-
13.553 13.567 MH
Communications Interface Board Accessory
The CI Board contains a radio frequency
wireless, local-area network interface (
®
allows the Alaris System to communicate with the Alaris
Server connected to the hospital information system. The
card is compliant with the rules and regulations in the locations
where the C I Board is sold, and is labeled as required.
The United States Federal Communications Commission
( ) and Canadian Department of Communications (
FCC
identification numbers are visible through the C I Board's clear
plastic cover. If an international country approval stamp is
required, it is placed adjacent to the identification numbers in
the area provided.
Alaris ® System (with v9 Model 8000) DFU
Appendix Section
Compliance (Continued)
IEC 60601-2-24
z, the higher frequency range applies.
frequency bands between
ISM
z, are intended to decrease the likelihood that mobile/portable communications
2.5 GH
/ is used in calculating the recommended separation distance for transmitters in
10 3
/ radio broadcast,
AM FM
compliance level, the Alaris
RF
®
System.
kHz -
150 80 MH
z, -
26.957 27.283 MH
RF
.
150
broadcast] cannot be predicted theoretically with
TV
z, field strengths should be less than [
150
z, and -
40.66 40.70 MH
b,
IEEE 802.11
card). The card
RF
®
RF
)
DOC
kHz and z, and in the frequency
80 MH
transmitters, an electromagnetic
RF
®
System should be observed to verify
]
V V
1
kHz and z are
80 MH
z.
Regulations and Standards
®
System
/m.
- z,
6.765 6.795 MH
A-11