Utilizing the Auto-ID Module to scan
provides the ability to verify the right medication and
concentration, and enhances safety through the use of the
®
Guardrails
Suite
MX
from the
container bar code with the medication identifier
IV
from the Drug Library. If the patient
bar code, the system also verifies the right patient.
When the green
READY LED
scan.
1.
To scan bar code on
key on Auto-ID Module or scan trigger on hand-held
scanner.
2.
Press
CHANNEL SELECT
3.
Program infusion (see applicable module-specific Section
of this DFU).
NOTES:
The Alaris
®
System determines if the module selected is
appropriate for the scanned medication type. If the selection
is not appropriate (for example, a bag was scanned but a
Module was selected), a pop-up warning displays with a
PCA
request to
CONFIRM
If a continuous Guardrails
checks to verify scanned and infusing medication and
concentration are the same. If not, an error message displays
with a request to
cancelled.
6-6
Programming
Primary Infusion
medication containers
IV
. It compares the medication identifier
is in the
ID
illuminates, the system is ready to
container, press
IV
key on appropriate module.
the message, and the scan is cancelled.
®
infusion is running, the system
the message, and the scan is
CONFIRM
container
IV
/
SCAN
CANCEL
CAUTIONS
•
CLASS 1 LED PRODUCT
stare into the beam or allow beam
to strike patient's face.
• Always verify that information
displayed on the PC Unit matches
scanned data.
®
Alaris
System (with v9 Model 8000) DFU
Auto-ID Module Section
: Do not