Monitoring Mode - Cardinal Health Alaris Directions For Use Manual

Display references throughout this procedure are for illustration
purposes only.
See "General Information", "Features and Displays" and
PC Unit Section of this DFU for information about:
• Displays
• Operating Features, Controls, Indicators
1. Perform following steps (see PC Unit Section of this DFU,
"General Setup and Operation", "Start-Up"):
a. Power on system.
b. Choose Yes or No to New Patient?
c. Confirm current profile or select a new profile.
d. Enter patient identifier, if required.
2. Connect Microstream
3. Press
CHANNEL SELECT
•
SENSOR WARMING
Channel Message display until
rate readings stabilize (up to
4. To change settings, see "Setting Alarm Limits" procedure.
OR
-- Continued on Next Page --
®
Alaris System (with v9 Model 8000) DFU
EtCO Module Section
2

Monitoring Mode

® Disposable (see "Getting Started").
key.
and then
SEARCHING
t and respiratory
E CO
2
seconds).
60
appear in
Programming
EtCO (mm Hg)
2
RR (breaths/min)
CHANNEL
SELECT
MONITOR
CHANNEL
OFF
5-5
Programming