Programming An Infusion With Pca Pause Protocol Enabled - Cardinal Health Alaris Directions For Use Manual

Programming an Infusion with PCA Pause Protocol Enabled

1. Perform steps
1
an Infusion".
Confirm drug and concentration selections and press Yes
2.
soft key.
3. If facility has chosen to enable optional PCA Pause
Protocol, review Clinical Advisory. To continue, press
CONFIRM
soft key.
To activate PCA Pause Protocol, attach and start an
EtCO Module and/or SpO
2
• Verify appropriate monitoring modules are attached to
PC Unit and press
4. Verify parameters are correct and press
confirm.
• Clinical Advisory appears.
CONFIRM
5. Press
6. Start applicable infusion, as described in following
procedures:
Setting Up PCA Dose Only
Setting Up Continuous Infusion Only
Setting Up PCA Dose + Continuous Infusion
Setting Loading Dose Only
®
Alaris System (with v9 Model 8000) DFU
PCA Module Section
- in "Preparing Infusion", "Programming
8
Module per facility protocol.
2
CONFIRM
soft key.
soft key.
next
soft key to
A
Clinical Advisory:
Attach an SpO2 or EtCO2
module now.
The drug selected will
activate the PCA Pause
Protocol once a monitoring
device is operating.
>Press CONFIRM
EXIT
CONFIRM
A
PCA Pause Limits
should be reviewed.
Press PAUSE LIMITS to
review the current settings.
Press CONFIRM to continue
programming the PCA
infusion.
>Press CONFIRM
PAUSE
CONFIRM
LIMITS
Programming
3-33