Geely EC718 2009 Workshop Manual page 608

2-526 Ignition System JL4G18-D
IF12
IF15
IF9
IF10
IF8
Yes
Replace the ignition relay IG1.
Step 4
Step 5 Check ignition switch IG1 power output.
Ignition Switch
Yes
The circuit between ignition switch wiring harness connector IP23 terminal No.2 and the ignition relay IG1
Step 6
terminal No.86 is open.
Next
Diagnostic completed.
Step 7
2.10.7.5 Spark Plug Does Not Arcing
Note
Before carry out the Spark Plug do not arcing diagnostic, make sure that the engine anti-theft locking system is not
activated and working properly.
EC718/EC718RV EC715/EC715RV 10/2009
IF26
IF3
IF28
IF16 IF21
IF30
F17
85
87
F22
30
86
FE02-9004b
FE02-9005b
(a) Turn the ignition switch to "OFF" position.
(b) Remove ignition relay.
(c) Measure voltage between ignition relay IG1 terminal No.87
and a reliable ground.
Standard Voltage: 11-14 V
Is the voltage specified value?
The circuit between the relay terminal No.87
No
and fuse EF22 is open.
(a) Turn the ignition switch to "ON" position.
(b) Measure voltage between ignition switch harness connector
IP23 terminal No.2 and a reliable ground. (Note: During this
test, the ignition switch wiring harness connector can not be
disconnected).
Standard Voltage: 11-14 V
Is the voltage specified value?
Check the ignition switch, refer to
No
the2.10.7.3 Check Ignition Switch
Engine