Geely EC718 2009 Workshop Manual page 713

Engine
Scan Tool Display
Item
High-Speed Fan
Air-Conditioning Clutch
Ignition Advance Angle
Fuel Injector
BLM Learn
Fuel Open-Loop Control ECM Open-Loop Control
BLM Reset
Idle Catalyst Monitor
ETC Motor
Reset TPS Learn Value
Intake Camshaft
Phasing Device
Intake Camshaft Valve
Timing Control Device
Test Component
Enable the High-Speed cooling
fan
Enable the Air-Conditioning
compressor clutch.
Control the ignition advance
angle
Disable the fuel injection
(Cylinder No.1, Cylinder No.2,
Cylinder No.3, Cylinder No.4).
Fuel closed-loop learn
Fuel Closed-Loop Learn
Enable catalyst monitor
diagnostics
Electronic throttle body
movements
Clear throttle position sensor
learn value
Used to control the VVT's
current valve timing, the control
parameter is not a percentage,
but the target valve timing.
VVT Control Valve Control
Signal Duty Cycle Test
Control System JL4G15-D
Control Range
Note
Carry out this test only when the engine
coolant temperature is below 100°C
(212 ºF) and Air-Conditioning is not switched
ON/OFF
on.
This function controls the High-Speed cooling fan
relay. When the instruction is received, the cooling
fan will be on at high speed for 5 s.
Note
Carry out this test only when the ignition
switch is at "ON" position and the engine is
not running.
ON/OFF
This function controls Air-Conditioning
compressor relay. When the instruction is "ON",
the Air-Conditioning compressor relay will be on
or off in 3-5 s.
0, 45, 246, 255
ON/OFF
Fuel closed-loop learn not allowed when the
ignition switch is ON.
- Based on the software logic, decide whether to
conduct relevant learn when the ignition switch is
OFF.
ON/OFF
ON/OFF All fuel closed-loop learn values reset to 1
ON/OFF
0, 50%, 100%
-
0, 30%, 60%
0, 50%, 100%
EC718/EC718RV EC715/EC715RV 10/2009
Diagnosis Description
-
-
-
-
-
-
-
-
2-631