Geely EC718 2009 Workshop Manual page 835

Engine
Next
Use scan tool to confirm whether the DTC code is stored again.
Step 9
Yes
Diagnostic completed.
Step 10
5. Repair Instructions:
Replace throttle valve. Refer to "Throttle Replacement".
Refer to 2.2.8.8 Engine Control Module
2.12.7.43 DTC P0562 P0563
1. DTC Descriptor:
DTC P0562
DTC P0563
ECM Power Supply Circuit consists of the following circuits:
– Battery power passes through main fuse and EF04 to ECM harness connector EO35 terminal No.1.
– When the ignition switch turned to "ON" position, battery power passes through the ignition switch wiring harness connector IP23
terminal No.6 to the ECU fuse 10, and finally to ECM harness connector EO35 terminal No. 3.
–
When ECM detects both ECM harness connector EO35 terminal No.3 and ECM connector EO35 terminal No.62 have battery
voltage, ECM grounds EO35 terminal No.62 through an internal circuit. Because EO35 terminal No.62 and main fuse terminal
No.1 are connected, the main relay pulls in.
– When main relay pulls in, the battery power passes through main relay terminal No.3 to ECM harness connector EO35 terminals
No.6 and 22.
ReplacementReplace ECM.
System Voltage Too Low
System Voltage Too High
Control System JL4G15-D
(b) Carry out crankshaft position sensor self learn. Refer to the
"crankshaft position sensor to learn."
(a) Connect scan tool to the datalink connector.
(b) Turn the ignition switch to "ON" position.
(c) Clear DTC code.
(d) Start and run the engine at idle speed to warm up the engine
for at least 5 min.
(e) Read control system DTC code again to confirm that the
system has no DTC code.
Intermittent Fault. Refer to
No
Fault Check
EC718/EC718RV EC715/EC715RV 10/2009
2-753
2.2.7.3 Intermittent