Inspection Procedure - Geely EC718 2009 Workshop Manual

Transmission / Drive Axle
3.3.8 Removal and Installation
3.3.8.1 Transmission Fluid Level Inspection

Inspection Procedure:

Note
If inspect the transmission fluid when the transmission
fluid temperature is too high, it may cause burns.
1. Park the vehicle on a level ground, wait for the
transmission fluid cooling down, remove the transmission
fill plug and check the transmission fluid level (Arrow
shown in the graphic).
Transmission fluid level should be even with the lower
edge of plug.
2. If the transmission fluid level is too low, add the dedicated
manual transmission fluid through the plug to until the fluid
begins to flow out.
3. Reinstall and tighten transmission fluid plug.
FE03-0001b
4. If needed, replace the transmission fluid. Remove the
transmission fluid plug, drain the transmission fluid (Arrow
shown in the graphic).
Manual Transmission
EC718/EC718RV EC715/EC715RV 10/2009
3-49