Geely EC718 2009 Workshop Manual page 246

2-164 Control System JL4G18-D
Camshaft Position Sensor Harness Connector EN15
1
Yes
Test ECM internal low reference circuit.
Step 4
Camshaft Position Sensor Harness Connector EN15
1
Yes
Step 5 Replace the camshaft position sensor. Refer to
Step 6 Check the sensor 5 V reference voltage circuit.
EC718/EC718RV EC715/EC715RV 10/2009
2 3
FE02-5087b
2 3
FE02-5088b
(a) Turn the ignition switch to "OFF" position.
(b) Disconnect camshaft position sensor wiring harness
connector EN15.
(c) Turn the ignition switch to "ON" position.
(d) Measure voltage between camshaft position sensor wiring
harness connector EN15 terminal No.2 and a reliable ground.
Standard Voltage: 4.5-5.5 V
(e) Connect camshaft position sensor wiring harness connector
EN15.
Is the value specified value?
Go to step 7
No
(a) Turn the ignition switch to "OFF" position.
(b) Disconnect camshaft position sensor wiring harness
connector EN15.
(c) Turn the ignition switch to "ON" position.
(d) Measure voltage between camshaft position sensor wiring
harness connector EN15 terminal No.1 and a reliable ground.
Standard Resistance: Less than 3 Ω
(e) Connect camshaft position sensor wiring harness connector
EN15.
Is the value specified value?
Go to step 8
No
2.10.8.1 Camshaft Position Sensor
Go to step 12
Next
Engine
Replacement.