Geely EC718 2009 Workshop Manual page 452

2-370 Engine Mechanical System JL4G18-D
3
11
7
9
5
EC718/EC718RV EC715/EC715RV 10/2009
1 6 8
2 4 10
FE02-0184b
FE02-0185b
FE02-0186b
5. Gradually tighten the camshaft cover bolts according to
the sequence as shown in the graphic.
Note
Tighten the bolts during several stages. Do not
tighten at once which may damage the camshaft
and the camshaft cover.
Torque:
M6 Bolts 13 Nm (Metric) 10 lb-ft (US English)
M8 Bolts 23 Nm (Metric) 17 lb-ft (US English)
6. Install the exhaust camshaft sprocket.
Note
Check for the sprocket pin wear. IF there is wear,
replace the sprocket pin. Hold the camshaft with a
wrench and then tighten the VVT actuator bolts.
Torque: 55 Nm (Metric) 41 lb-ft (US English)
7. Install the intake camshaft VVT actuator.
Note
Check for the sprocket pin wear. Hold the camshaft
with a wrench and then tighten the sprocket bolts.
Torque: 70 Nm (Metric) 52 lb-ft (US English)
8. Install the timing chain.
9. Install the timing chain cover.
10. Install the drive belt
11. Install the cylinder head cover.
12. Install the engine plastic shield.
13. Connect the battery negative cable.
Engine