Geely EC718 2009 Workshop Manual page 284

2-202 Control System JL4G18-D
No
Inspect (repair) fuel injectors.
Step 9
No
Check the ignition coil.
Step 10
No
Step 11 Replace the ignition coil.
No
Check crankshaft position sensor and circuit.
Step 12
EC718/EC718RV EC715/EC715RV 10/2009
(b) Replace fuel pump assembly. Refer to
Assembly Replacement.
Start the engine, fault solved?
System normal
Yes
(a) Inspect (repair) fuel injectors. Refer to the DTC
code2.2.7.24 DTC P0201 P0261
procedures. If necessary, replace the faulty fuel injectors.
Start the engine, fault solved?
System normal
Yes
(a) Turn the ignition switch to "OFF" position.
(b) Remove the cylinder ignition wire. Connect a new wire
connect the spark plug to a reliable ground.
(c) Remove the fuel pump fuse.
(d) Start the engine.
Is spark plug ignition normal?
Go to step 13
Yes
(a) Turn off the ignition switch and remove the ignition key.
(b) Replace the ignition coil. Refer to
Replacement.
Start the engine, fault solved?
System normal
Yes
(a) Check crankshaft position sensor. Refer to
P0321 P0322.
(b) Measure the crankshaft position sensor resistance with a
multimeter.
Standard Resistance: 870 Ω
(c) Inspect the sensor circuit. Repair the faulty part. If necessary,
replace the crankshaft position sensor. Refer to
2.10.8.2 Crankshaft Position Sensor
Start the engine, fault solved?
Engine
2.3.8.3 Fuel Pump
P0262in the repair
2.10.8.3 Ignition Coil
2.2.7.29 DTC
Replacement.