Geely EC718 2009 Workshop Manual page 819

Engine
Yes
Diagnostic completed.
Step 13
5. Repair Instructions:
Replace CMP sensor. Refer to
2.12.7.37 DTC P0351 P0352
1. DTC Descriptor:
DTC P0351
DTC P0352
Ignition coil 1 provides ignition for cylinders No.1 and 4. Ignition coil 2 provides ignition for cylinders No.2 and 3. Ignition relay provides
power time to the two ignition coils at the same time. ECM controls cylinders No.1 and 4 primary ground circuit through ECM harness
connector EO01 terminal No.1. ECM controls cylinders No.2 and 3 primary ground circuit through ECM harness connector EO01
terminal No.17.
2. Conditions For Setting DTC and The Fault Location:
DTC Code DTC Detection Strategy
P0351
Hardware Circuit Checks
P0352
2.10.8.1 Camshaft Position Sensor
Ignition Coil 1 Malfunction
Ignition Coil 2 Malfunction
Conditions For Setting The DTC
Operating at idle, with the ignition coil
control end disconnected, short to
ground and short to power supply,
this DTC code will be set. The fuel
injection to the cylinder with this DTC
code stops. Engine speed fluctuates.
Control System JL4G15-D
Intermittent Fault. Refer to
No
Fault Check
Replacement.
(Control Strategy)
EC718/EC718RV EC715/EC715RV 10/2009
2.2.7.3 Intermittent
Fault Locations
1. Ignition Coil Circuit
2. Ignition Coil
3. ECM
2-737