Geely EC718 2009 Workshop Manual page 709

Engine
DTC Code Diagnostic
DTC Code
P0601 ROM Error
P0602 ECM Processor Malfunction
P0604 RAM error
Air-Conditioning Clutch Relay Short
P0646
To Low Voltage or Open Circuit
Air-Conditioning Clutch Relay Short
P0647
To High Voltage
P0650 Fault Indicator Malfunction
P0685 Main Relay Malfunction
P2610 LPC Malfunction
Alarm does not learn from
P0633
malfunction.
U0167 Anti-theft Device No Response
Anti-theft Device Authentication
U0426
Failure
2.12.7.9 Data Stream List
By reading the "Data Stream List" on the scan tool, you can check switches, sensors, actuators working state without removing any
parts. Before the control system diagnosis, observing and analyzing data is the first step, so that the diagnose time could be
shortened.
Note
Data under normal conditions is listed in the following table for reference only. Do not determine whether a part is faulty
solely based on these reference values. Under normal circumstances you can compare the vehicle that needs to be
repaired with a normal working vehicle in the same state to determine the current vehicle diagnostic data is normal or
not.
1. Run the engine to reach normal working temperature.
2. Turn the ignition switch to "OFF" position.
3. Connect the scan tool.
4. Turn the ignition switch to "ON" position.
5. Select "Engine"/"Read data stream."
Information
Vehicle can not start.
Vehicle can not start.
Vehicle can not start.
No
No
No
Vehicle may not start.
No
SVS lamp flashing; vehicle can not
start.
Control System JL4G15-D
Fail-Safe Mode
EC718/EC718RV EC715/EC715RV 10/2009
Restore Conditions
Next key cycle, no malfunction
condition detected.
Next key cycle, no malfunction
condition detected.
Next key cycle, no malfunction
condition detected.
No malfunction condition detected.
Next key cycle, no malfunction
condition detected.
No malfunction condition detected.
(1) Open circuit, no malfunction
condition detected.
(2) Short to power supply. Next key
cycle, no malfunction condition
detected.
No malfunction condition detected.
Next key cycle, IMMO learn
successful, or No malfunction
condition detected.
2-627