Geely EC718 2009 Workshop Manual page 654

2-572 Starting / Charging System JL4G18-D
Note
When the system parasitic current can not be confirmed, compare the vehicle with a known good vehicle to helping
with diagnostic.
2.11.7.10 Jump Start Procedure
Warning!
Refer to "Battery Disconnection Warning" in "Warnings and Notices".
Park the vehicle that will provide jump starting power properly to make sure the jumper cable can connect
Step 1
two vehicles batteries.
Next
Turn both vehicles' ignition switch to "OFF" position and turn off headlights and all the accessories power
Step 2
supplies.
Next
Press the hazard warning lamp switch, so that hazard warning lamps are on.
Step 3
Next
Apply two vehicles parking brake.
Step 4
Next
Step 5 Make sure that the transmission gears are in neutral gear position.
Next
Connect one end of the red cable to the positive terminal of the battery with sufficient capacity providing the
Step 6
power, and confirm that there is no contact with other metal parts.
Next
Connect the other end of the red cable the positive terminal of the flat battery. Do not connect the red cable
Step 7
to the negative terminal of flat battery.
Next
Connect one end of the black cable to the negative terminal of the battery with sufficient capacity providing
Step 8
the power.
EC718/EC718RV EC715/EC715RV 10/2009
Warning!
The jumper cable must be intact without exposed wires, otherwise
it will cause unnecessary personal injury or vehicle damage.
Warning!
Do not connect the jumper cable directly to a flat battery negative
terminal to prevent the spark and possible battery gas explosion.
Engine