Geely EC718 2009 Workshop Manual page 363

Engine
Anti-theft Engine Control Module Wiring Harness Connector 2
Engine Anti-Theft Control Module Harness
Connector IP26
1
Terminal Terminal
ID Definition
1 Coil Connector 1
2 Coil Connector 2
3 -
2.5.7.4 DTC code (DTC) list
DTC
Antenna Failure (Only When Read Anti-theft Transponder, Not
B1000
Received During Continuous Test).
Encryption and Decryption Validation Errors In The W Line (Set When
B3040
Ending Communication Without "Responding To End Communication").
W wire short to ground (If the EMS communication was set to the low
B3042
bit).
W line short to power supply (when the anti-theft device sends wake-up
B3043
low voltage signal and detected set to continuous high-bit).
B3045 LED line is short to ground or open, or LED-line damage.
B3048 LED short to power supply.
No anti-theft transponder modulation signal or no anti-theft
B3055
transponders.
B3056 no programmed anti-theft transponder idE
B3057 no programmed security code.
No engine EFI request (set when the last time the ignition signal was
B3059
received but R-line signal was not received.).
2 3
FE02-6604b
Wire
W/G 125 KHz Modulation Waveform
Gr/O 125 KHz Modulation Waveform
- -
Descriptions
Engine Anti-theft System JL4G18-D
Rated Working Voltage
EC718/EC718RV EC715/EC715RV 10/2009
Working Terminal
Current Instructions
- Antenna Signal
- Antenna Signal
-
Recorded Before
Yes NO
X
X
X
X
X
X
X
X
X
X
2-281
-
Output
Sequence
1
7
5
6
11
12
8
2
3
4