Geely EC718 2009 Workshop Manual page 870

2-788 Control System JL4G15-D
Yes
Diagnostic completed.
Step 7
2.12.7.56 DTC P2610
Lack of information, to provide in the future.
2.12.7.57 DTC P0633 U0167 U0426
1. DTC Descriptor:
DTC P0633
DTC U0167
DTC U0426
ECM communicates with Anti-theft control module through ECM harness connector EO01 terminal No.62 R-LIN circuit and wiring
harness connector EO35 terminal No.72 R-LIN circuit. For details, Refer
2. Conditions For Setting DTC and The Fault Location:
DTC Code
P0633 Alarm Does Not Learn Malfunction
U0167 Anti-theft Device No Response
EC718/EC718RV EC715/EC715RV 10/2009
Alarm Does Not Learn Malfunction
Anti-theft Device No Response
Anti-theft Device Authentication Failure
DTC Detection Strategy
(d) Start and run the engine at idle speed to warm up the engine
for at least 5 min.
(e) Road test the vehicle for at least 10 min.
(f) Read control system DTC code again to confirm that the
system has no DTC code.
Intermittent Fault. Refer to
No
2.12.7.3 Intermittent Fault Check
to11.17 Data Communication
Conditions For Setting The
DTC (Control Strategy)
Ignition Switch "ON".
Ignition Switch "ON".
Engine
System.
Fault Locations
1. Ignition Key
2. Ignition Key Incentive Coil
3. ECM
4. Chip Security Module
5. Data Circuit (W-LIN Circuit,
R-LIN Circuit)
1. Ignition Key
2. Ignition Key Incentive Coil
3. ECM
4. Chip Security Module
5. Data Circuit (W-LIN Circuit,
R-LIN Circuit)