Engine Control Module; Body Control Module - Geely EC718 2009 Workshop Manual

Engine
2.5.2 Description and Operation
2.5.2.1 Description and Operation
Engine Anti-theft system feature is realized by the engine
control module (IMMO) and the engine control module (ECM).
Engine anti-theft system components are listed below:
– Anti-theft system Engine Control Module (IMMO)
– Engine Control Module (ECM)
–
Body Control Module (BCM)
– Electronic Anti-theft Coil (Motor Anti-theft System,
Antennas)
– Ignition Key (Transponder)
–
Engine Trouble Indicator Light (MIL)
1. Ignition Key (Transponder)
Inside the plastic key cover of the ignition key there is a
transponder. The information contained in the transponder is
fixed and can not be changed. Vehicle anti-theft system uses
the engine ignition key transponder information to determine
whether the key used to start the vehicle ignition is valid. In
addition to the ignition key, it can open the door lock system
and also has a launch vehicle feature.
2. Electronic Anti-theft Coil (Engines Antenna
Anti-theft System)
The electronic Anti-theft ignition coil is installed in the cylinder.
When the ignition key is inserted into the ignition cylinder ON
position, the electronic Anti-theft ignition coil will generate
electromagnetic fields to stimulate the transponder keys to
send out a signal. Electronic anti-theft transponder coil detects
this signal and sends it to the engine control module anti-theft
system.
Integrated on the electronic anti-theft coil there is a light-
emitting diode lighting circuit controlled by the interior light
circuit in order to facilitate the driver to locate the ignition
cylinder.
3. Engine Anti-theft System Control Module
The engine control module anti-theft system is installed in the
driver's side below the instrument platform, when it receives a
signal from the electronic anti-theft transponder coil. The
engine control module anti-theft system compares this signal
with key information in the memory to send the fuel engine
control module enable / disable instruction.
Engine Anti-theft System JL4G18-D
Note
If the anti-theft system can not get the ignition key
transponder information, it will not send any signal to the

engine control module.

4. Engine Control Module
Engine control module is installed under the passenger side of
instrument panel, near the air-conditioning blower. Based on
the signal received from the engine control module anti-theft
system, it sends instruction to enable / disable fuel injection.
Based on the instruction received from the engine control
module anti-theft system, engine control module will decide
whether to send the engine control module to the body lock /
unlock status information.
Based on the instruction received from the engine control
module anti-theft system, engine control module will decide
whether to send to the instrument cluster the "Light the engine
anti-theft system warning lamp" request.

5. Body Control Module

Body control module is installed in the driver's side instrument
panel left side bottom. it receives engine lock / unlock status
information from the engine control module.
If it receives the engine unlocked information, the starter will
get power and the vehicle will start.
If it receives the engine unlocked information, it will disconnect
the starter power supply, thus prohibiting the engine running.
At the same time body control module will activate the remote
control alarm system.
6. Engine Failure Warning Light (MIL)
When the instrument cluster receives a "Light the engine anti-
theft system warning lamp" request from the engine control
module, it will enable engine malfunction indicator light
flashing, until the ignition is off.
EC718/EC718RV EC715/EC715RV 10/2009
2-275