Geely EC718 2009 Workshop Manual page 826

2-744 Control System JL4G15-D
Evaporative Canister Solenoid
B
Yes
Measure canister solenoid valve working power supply.
Step 3
Evaporative Canister Solenoid Harness
Connector EO24
Yes
Check canister solenoid valve control circuit.
Step 4
EC718/EC718RV EC715/EC715RV 10/2009
A
FE02-5283b
B
A
FE02-5284b
(a) Turn the ignition switch to "OFF" position.
(b) Disconnect Canister solenoid valve harness connector
EO24.
(c) Measure resistance between the Canister solenoid valve two
terminals.
Standard Resistance: 19-22 Ω at 20°C(68 ºF)
(d) Connect canister solenoid valve harness connector EN24.
Is the value specified value?
Replace the canister solenoid valve. Refer to
No
2.4.7.3 Canister Solenoid Valve
Replacement.
(a) Turn the ignition switch to "OFF" position.
(b) Disconnect Canister solenoid valve harness connector
EN24.
(c) Turn the ignition switch to "ON" position.
(d) Measure voltage between Canister solenoid valve wiring
harness connector EN24 terminal A and a reliable ground.
Standard Voltage: 11-14 V
(e) Connect canister solenoid valve harness connector EN24.
Is the value specified value?
Check whether there is an open circuit or a
No
circuit short to ground between solenoid valve
wiring harness connector EN24 terminal A
and main relay terminal No.3. Repair the
faulty part. Go to step 7
Engine