Geely EC718 2009 Workshop Manual page 810

2-728 Control System JL4G15-D
No
Intermittent Fault. Refer to
Step 3
Check the crankshaft position sensor.
Step 4
Crankshaft Position Sensor
C
Yes
Check sensor terminal No.A circuit.
Step 5
EC718/EC718RV EC715/EC715RV 10/2009
2.12.7.4 Symptoms
A
B
FE02-5278b
Standard Value: Normal data. Refer to
(f) If the engine does not start, check the data with the engine
running.
(g) If the engine speed is shown as "0", it indicates the circuit
between the crankshaft position sensor and ECM wiring
harness open or short.
Go to step 4
Yes
Table.
(a) Turn the ignition switch to "OFF" position.
(b) Disconnect the crankshaft position sensor wiring harness
connector EO26.
(c) Measure crankshaft position sensor resistance.
Standard Resistance: 504-616 Ω at 25°C(77 ºF)
(d) Connect the crankshaft position sensor wiring harness
connector EN26.
Is resistance normal?
Replace the crankshaft position sensor. Refer
No
to 2.10.8.2 Crankshaft Position Sensor
Replacement.
Engine
2.12.7.9 Data Stream List.