3-46
Manual Transmission
Yes
Step 4
Check the shift control assembly.
No
Step 5
Inspect the faulty gear fork locking pin.
Next
System normal.
Step 6
3.3.7.5 Hard to Disengage
The following table shows the location the fault may occur, check each component, if necessary, replace these components.
Symptoms
Hard to Disengage
EC718/EC718RV EC715/EC715RV 10/2009
(a)
Is the gear self-locking nut installed correctly?
No
FE03-2023b
(a)
Remove the shift control assembly to check for wear and tear
or deformation.
Yes
(a)
Remove the transmission.
(b)
Disassemble the transmission. Check the shift fork for
deformation.
(c)
Replace the damaged shift fork.
(d)
Confirm repair completed.
Suspected Parts
1. Shift Lever
Transmission / Drive Axle
Tighten or replace the gear self-locking nut.
Replace the shift control assembly.
Refer to
3.3.8.9 Shift Lever
Replacement.