Geely EC718 2009 Workshop Manual page 976

3-22 Clutch System
EC718/EC718RV EC715/EC715RV 10/2009
3.2.6.5 Clutch Assembly Replacement
Removal Procedure:
Warning!
Refer to "Battery Disconnection Warning" in "Warnings
and Notices".
1. Disconnect the battery negative cable. Refer to
2.11.8.1 Battery Disconnection.
2. Lift the vehicle.
3. Remove the engine bottom shield. Refer to
and Right Engine Bottom Shield
4. Remove the transmission
3.3.8.3 Transmission Assembly
5. Remove clutch bolts, the clutch pressure plate and clutch
driven plate.
Installation Procedure:
1. Apply grease on the clutch plate spline.
2. With a special tool GL301-017, align the clutch pressure
plate and drive plate with the flywheel.
3. Install pressure plate bolts and tighten.
Torque: 25 Nm (Metric) 18.5 lb-ft (US English)
Note
Install bolts in diagonal order.
4. Remove the special tool GL301-017.
5. Install the transmission assembly.
6. Install the engine bottom shield.
7. Lower the vehicle.
8. Connect the battery negative cable.
3.2.6.6 Clutch Pilot Bearing Replacement
Removal Procedure:
Warning!
Refer to "Battery Disconnection Warning" in "Warnings
and Notices".
Transmission / Drive Axle
12.10.1.7 Left
Replacement.
assembly. Refer
Replacement.
to