Geely EC718 2009 Workshop Manual page 866

2-784 Control System JL4G15-D
Yes
Replace ECM. Refer to
Step 7
Next
Carry out crankshaft position sensor learn. Refer to
Step 8
Next
Use scan tool to confirm whether the DTC code is stored again.
Step 9
Yes
Step 10 Diagnostic completed.
5. Repair Instructions:
Acceleration pedal position sensor (APP) can only be replaced as an assembly. Do not disassemble. APP replacement Refer to
"Acceleration Pedal Position Sensor Replacement".
2.12.7.54 DTC P2135
1. DTC Descriptor:
DTC P2135
ECM compares TPS1 and TPS2 input signals. Two input signals' sum at any time should be close to 5V. If ECM detects difference
between the sum of TPS1 and TPS2 signals and the theoretical value is big, ECM will report the DTCs code.
EC718/EC718RV EC715/EC715RV 10/2009
2.2.8.8 Engine Control Module
Electronic Throttle Position Sensor 1 and 2 Circuits Relations Malfunctions
(a) Check ECM Power Supply Circuit and ground circuit. Refer to
2.12.7.43 DTC P0562
ECM power and ground circuits normal?
Power and ground circuits fault.
No
Replacement.
2.12.7.11 Crankshaft Position Sensor (CKP)
(a) Connect scan tool to the datalink connector.
(b) Turn the ignition switch to "ON" position.
(c) Clear DTC code.
(d) Start and run the engine at idle speed to warm up the engine
for at least 5 min.
(e) Road test the vehicle for at least 10 min.
(f) Read control system DTC code again to confirm that the
system has no DTC code.
Intermittent Fault. Refer to
No
2.12.7.3 Intermittent Fault Check
P0563.
Learn.
Engine