Geely EC718 2009 Workshop Manual page 857

Engine
Yes
Replace electronic throttle body.
Step 4
Next
Use scan tool to confirm whether the DTC code is stored again.
Step 5
Yes
Check ECM power supply circuit and ground circuit.
Step 6
Yes
Replace ECM. Refer to
Step 7
Next
Carry out crankshaft position sensor learn. Refer to
Step 8
Next
Use scan tool to confirm whether the DTC code is stored again.
Step 9
2.2.8.8 Engine Control Module
Control System JL4G15-D
(a) Replace electronic throttle body. Refer to the "Electronic
Throttle Body Replacement".
(a) Connect scan tool to the datalink connector.
(b) Turn the ignition switch to "ON" position.
(c) Clear DTC code.
(d) start the engine and idle speed warm-up run for at least 5 min.
(e) Read control system DTC code again to confirm that the
system has no DTC code.
diagnostic
No
(a) Check ECM power supply circuit and ground circuit. Refer to
2.12.7.43 DTC P0562
ECM power and ground circuits normal?
Repair power and ground circuit faults
No
Replacement.
2.12.7.11 Crankshaft Position Sensor (CKP)
(a) Connect scan tool to the datalink connector.
(b) Turn the ignition switch to "ON" position.
(c) Clear DTC code.
(d) Start and run the engine at idle speed to warm up the engine
for at least 5 min.
(e) Road test the vehicle for at least 10 min.
(f) Read control system DTC code again to confirm that the
system has no DTC code.
Intermittent Fault. Refer to
No
2.12.7.3 Intermittent Fault Check
EC718/EC718RV EC715/EC715RV 10/2009
P0563.
Learn.
2-775