Geely EC718 2009 Workshop Manual page 967

Transmission / Drive Axle
No
Check whether the clutch pedal height is correct, otherwise the clutch master cylinder can not be completely
Step 3
reset. Measure the clutch pedal free travel. Refer to
Next
Check whether the pipes are broken or damaged, causing the clutch slave cylinder oil pressure can not be
Step 4
released in time.
No
Check whether clutch fork or split is binding?
Step 5
No
Check whether the pressure plate spring is too soft. Replace the clutch pressure plate.
Step 6
Next
Diagnostic completed.
Step 7
3.2.5.6 Clutch Bearings Noisy When Release
Step 1 Check whether the bearing is binding?
No
Check whether the fork is installed incorrectly. Remove and re-install the correct fork.
Step 2
Next
Diagnostic completed.
Step 3
Clutch Rattle
Step 1 Check whether the pressure plate diaphragm spring is too soft?
No
Check whether the fork is not installed correctly, remove and re-install the correct fork.
Step 2
3.2.6.4 Clutch Pedal Free Travel
Replace the damaged pipe.
Yes
Separate bearings separate Fork. Refer to
Yes
3.2.6.6 Clutch Pilot Bearing Replacement
Clean and re-lubricate bearings. Check
Yes
whether the bearing is damaged.
Replace the clutch pressure plate
Yes
EC718/EC718RV EC715/EC715RV 10/2009
Clutch System
Adjustment.
3-13