2-780
Control System JL4G15-D
Yes
Replace ECM. Refer to
Step 7
Next
Carry out crankshaft position sensor learn. Refer to
Step 8
Next
Use scan tool to confirm whether the DTC code is stored again.
Step 9
Yes
Step 10
Diagnostic completed.
5. Repair Instructions:
Acceleration pedal position sensor (APP) can only be replaced as an assembly. Do not disassemble. APP replacement Refer to
"Acceleration Pedal Position Sensor Replacement".
2.12.7.53 DTC P2127 P2128
1. DTC Descriptor:
DTC
P2127
DTC
P2128
In order to protect the security of the system, acceleration pedal position sensor (APP) uses a dual-sensor setting, sliding resistive.
APP sensor 2 output is IP50 terminal No.6, through ECM wiring harness Connect EO35 terminal No.27 to ECM.
EC718/EC718RV EC715/EC715RV 10/2009
2.2.8.8 Engine Control Module
Electronic Throttle Pedal Position Sensor 2 Circuit Low Voltage
Electronic Throttle Pedal Position Sensor 2 Circuit High Voltage
(a)
Check ECM power supply circuit and ground circuit. Refer to
2.12.7.43 DTC P0562
ECM power and ground circuits normal?
Power and ground circuit fault.
No
Replacement.
2.12.7.11 Crankshaft Position Sensor (CKP)
(a)
Connect scan tool to the datalink connector.
(b)
Turn the ignition switch to "ON" position.
(c)
Clear DTC code.
(d)
Start and run the engine at idle speed to warm up the engine
for at least 5 min.
(e)
Road test the vehicle for at least 10 min.
(f)
Read control system DTC code again to confirm that the
system has no DTC code.
Intermittent Fault. Refer to
No
2.12.7.3 Intermittent Fault Check
P0563.
Learn.
Engine