2-154
Control System JL4G18-D
No
Intermittent Fault. Refer to
Step 3
Check the sensor.
Step 4
Crankshaft Position Sensor
Yes
Check sensor terminal No.1 circuit.
Step 5
EC718/EC718RV EC715/EC715RV 10/2009
Standard Value: Normal data. Refer to
(f)
(g)
2.2.7.4 Fault Symptom
Table.
(a)
(b)
(c)
Standard Resistance: 774-946 Ω at 23°C (73.4 ºF)
(d)
Is resistance normal?
FE02-5079b
If the engine does not start, check the data with the engine
running.
If the engine speed is shown as "0", it indicates the circuit
between the crankshaft position sensor and ECM wiring
harness open or short.
Go to step 4
Yes
Turn the ignition switch to "OFF" position.
Disconnect the crankshaft position sensor wiring harness
connector EN26.
Measure crankshaft position sensor resistance.
Connect the crankshaft position sensor wiring harness
connector EN26.
Replace the crankshaft position sensor. Refer
No
to
2.10.8.2 Crankshaft Position Sensor
Replacement. Go to step 10
Engine
2.2.7.9 Data Stream List