Geely EC718 2009 Workshop Manual page 496

2-414 Engine Mechanical System JL4G18-D
9 5
10 6
EC718/EC718RV EC715/EC715RV 10/2009
1 3 7
2 4 8
FE02-0269b
1
FE02-0484b
8. Install the crankcase, install and tighten the crankshaft
bearing cap bolts according to the sequence shown in the
graphic.
Torque
First Pass: 44 Nm (Metric) 32.5 lb-ft (US English)
Second Pass: 60 Nm (Metric) 44.5 lb-ft (US English)
9. Remove the crankcase.
10. Measure the width of the plastic strip, check whether the
value of crankshaft bearing clearance is within the
following range:
Standard Value:
0.015-0.033 mm (Metric) 0.0006-0.0013 in (US English)
11. If the gap value is not within the specified range, re-adjust
the crankshaft clearance. If necessary, replace the
crankshaft.
Installation Sequence:
1. Clean all the relevant parts.
2. Apply a small amount of engine oil to the crankshaft
bearing.
3. Install the selected crankshaft bearings.
Engine