Geely EC718 2009 Workshop Manual page 296

2-214 Control System JL4G18-D
EC718/EC718RV EC715/EC715RV 10/2009
4. Remove VVT solenoid valve retaining bolts and remove
the VVT solenoid valve.
Installation Procedure:
Note
After replacing the VVT solenoid valve, you must carry
out the "Clean Solenoid Valve Filter" procedure, other it
cause electromagnetic valve damage.
1. Make sure the new VVT solenoid valve seals are intact.
Apply a small amount of engine oil on the seal.
FE02-0042b
2. Install the VVT solenoid valve and fasten the retaining
bolts.
Torque: 8 Nm (Metric) 6 lb-ft (US English)
Engine