Geely EC718 2009 Workshop Manual page 364

2-282 Engine Anti-theft System JL4G18-D
B3060 Anti-theft transponder verification failed.
B3061 EFI controller verification failed.
Note
DTC (DTC code) is set based on the above-mentioned output sequence. But at the same time it only shows a maximum
of 7 DTC.
Note
DTC code history is code recorded before shown by the scan tool. If a DTC code has no historical features, it only
shows the current status. If there are historical features it can display the status up to 20 ignition cycles.
2.5.7.5 Data Flow Table
Serial
Number
1 Ignition Switch Position
2 Anti-theft Controller Hardware Malfunction
3 Coil Malfunction
4 Anti-theft Transponder
5 The Current Key Match
6 The Current Key Position
7 Key Storage Position 1
8 Key Storage Position 2
9 Key Storage Position 3
10 Key Storage Position 4
11 Key Storage Position 5
12 Security Certification
13 Anti-theft Verification
14 Password Settings
15 Password Lock
16 Remaining Numbers Of Times Entering The Password
2.5.7.6 Fault Symptom Table
Symptoms
Engine Anti-theft Indicator Always On
Engine Anti-theft warning lamp flashes frequently, the engine
can not start.
EC718/EC718RV EC715/EC715RV 10/2009
Name
Suspect Part
Instrument Panel
1. the key
2. Anti-theft Coil
X
X
Data
At ON Position
No Fault
No Fault
Yes
Have matched
Position 3
Not Stored
Not Stored
Stored
Stored
Stored
Passed
Yes
Yes
No
10
Refer to Page
Refer to 11.7.7.1 Instrument
Cluster Replacement.
Refer to 2.5.7.12 Engine Anti-
theft Warning Lamp Flashing,
Vehicle Can Not Start.
Engine
9
10