Geely EC718 2009 Workshop Manual page 973

Transmission / Drive Axle
1
2
2
1
3
FE03-0209b
1
FE03-0210b
Installation Procedure:
1. Install clutch master cylinder and tighten clutch master
cylinder retaining nuts (1).
Torque: 23 Nm (Metric) 17.0 lb-ft (US English)
2. Install piston rod U-shaped clip to the clutch master
cylinder piston rod, and tighten the clutch master cylinder
piston rod and the piston rod U-shaped locking nut (20.
Torque: 11 Nm (Metric) 8.1 lb-ft (US English)
3. Install connecting pin (3) between the clutch pedal and the
piston rod U-shaped clip, lock the pin (3).
4. Connect the clutch master cylinder metal connector 1.
Torque: 10 Nm (Metric) 7.4 lb-ft (US English)
5. Install the master cylinder oil inlet hoses, tighten the steel
clamp (2).
Torque: 14 Nm (Metric) 10.3 lb-ft (US English)
6. Bleed air.
7. Adjust the clutch pedal.
8. Install Instrument panel lower left shield panel.
9. Fill the clutch / brake fluid to the MAX (maximum) mark.
10. Connect the battery negative cable.
3.2.6.3 Hydraulic Clutch Bleeding
Note
Brake fluid is corrosive and it will damage electrical
connectors and paint. Use a suitable container and
fender cover to prevent exposure to brake fluid. Use
cotton cloth to wipe spilled fluid.
It is prohibited to refill brake fluid to the clutch master
cylinder brake fluid reservoir, because the used brake
fluid may be mixed with the air, impurities and moisture.
EC718/EC718RV EC715/EC715RV 10/2009
Clutch System 3-19