Geely EC718 2009 Workshop Manual page 295

Engine
Installation Procedure:
1. Install and tighten the throttle position sensor retaining
bolts.
Note
During the installation procedure align the throttle
shaft groove with the sensor boss.
2. Install the throttle body assembly.
3. Connect the battery negative cable.
FE02-0039b
2.2.8.4 VVT Solenoid Valve Replacement and
Filter Cleaning
Removal Procedure:
Warning!
Refer to "Battery Disconnection Warning" in the
"Warnings and Important Notices".
1. Disconnect the battery negative cable. Refer to
2.11.8.1 Battery
2. Remove the hood. Refer to
Replacement.
3. Disconnect VVT solenoid valve wiring harness connector.
FE02-0040b
Control System JL4G18-D
Disconnection.
2.6.8.1 Plastic Engine Shield
EC718/EC718RV EC715/EC715RV 10/2009
2-213