Geely EC718 2009 Workshop Manual page 752

2-670 Control System JL4G15-D
Yes
Replace ECM.
Step 5
Next
Step 6 Use scan tool to confirm whether the DTC code is stored again.
Yes
Step 7 Diagnostic completed.
5. Repair Instructions:
Electronic throttle body (ETC) can only be replaced as an assembly. Do not disassemble it and repair. Refer to
Throttle Body Replacementreplacement.
2.12.7.22 DTC P0131 P0132 P0133 P0134
1. DTC Descriptor:
DTC P0131
DTC P0132
DTC P0133
DTC P0134
EC718/EC718RV EC715/EC715RV 10/2009
Pre-Catalytic Oxygen Sensor Circuit Short To Low Voltage
Pre-Catalytic Oxygen Sensor Circuit Short To High Voltage
Pre-Catalytic Oxygen Sensor Slow Response
Pre-Catalytic Oxygen Sensor Circuit Open
(a) Replace ECM. Refer to
Replacement.
(b) Carry out crankshaft position sensor self learn. Refer to
2.12.7.11 Crankshaft Position Sensor (CKP)
(a) Connect scan tool to the datalink connector.
(b) Turn the ignition switch to "ON" position.
(c) Clear DTC code.
(d) Start and run the engine at idle speed to warm up the engine
for at least 5 min.
(e) Read control system DTC code again to confirm that the
system has no DTC code.
Intermittent Fault. Refer to
No
Fault Check
2.2.8.8 Engine Control Module
Learn.
2.2.7.3 Intermittent
2.16.3.2 Electronic
Engine