Operationenabled; Warning; Troubleqsp; Trouble - Lenze 8400 StateLine C Reference Manual

4.2.7

OperationEnabled

LED DRIVE READY
The drive controller is in this device status if the controller inhibit is deactivated and no
error ("Trouble" or "TroubleQSP") has occurred.
If the operation is enabled and the magnetisation in case of sensorless vector control
(SLVC) has been completed, the motor follows the setpoint determined by the active
application.
Depending on certain conditions, a status change takes place based on the
"OperationEnabled" device status.
Change condition
Control bit "EnableOperation" of a control channel = "0"
OR terminal RFR = LOW level (controller inhibit).
Control bit "SwitchOn" of a control channel = "0".
Undervoltage in the DC bus.
Error with error response "Trouble" occurs.
Error with error response "TroubleQSP" occurs.
Related topics:
wCANControl/wMCIControl control words
4.2.8

Warning

LED DRIVE READY
This display may occur in all device statuses if a monitoring mode responds, the error
response "Warning" or "Warning locked" has been parameterised for.
 If the error is no longer active, the previous device status is displayed.
Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
8400 StateLine C | Reference manual
LED DRIVE ERROR Display in
OFF OperationEnabled
LED DRIVE ERROR Display in
Warning
L
Device control (DCTRL)
Device state machine and device statuses
C00137 Display in status word 1 (C00150)
Bit 11 Bit 10
0 1
Changeover to the device status
SwitchedOn
ReadyToSwitchOn
Trouble/Fault (depending on C00600/1)

Trouble

TroubleQSP

( 103)
C00137 Display in status word 1 (C00150)
Bit 11 Bit 10
0 1
Bit 9 Bit 8
0 1
Bit 9 Bit 8
1 0
93