Parameterising The Application - Lenze 8400 StateLine C Reference Manual

8400 StateLine C | Reference manual
Commissioning
Commissioning of the "Switch-off positioning" technology application
3.7.4

Parameterising the application

The application parameters can be found on the right side of the Application parameter
tab:
1. Select the "switch-off positioning" mode in the
– After the "Switch-off positioning" application is selected, the contents of the tab
change, e.g. the Process controller and Motor potentiometer buttons are not shown
any more.
2. In the
switch-off positioning without pre-switch off the
selected.
– The corresponding wiring diagram is displayed in a pop-up window if you click the
button right to the list field.
– For a detailed description, see the chapter
modes".
66
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Control mode list field (C00007) and in case of illustration [3-2], for the shown
( 302)
L
Application (C00005) list field.
"Terminals 2" control mode must be
"Terminal assignment of the control
Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011