Main Setpoint Path - Lenze 8400 StateLine C Reference Manual

8400 StateLine C | Reference manual
Function library
Function blocks | L_NSet_1
Parameter
C00221
C00241
C00632/1...3
C00633/1...3
C00634
C00635
C00636
16.1.29.1

Main setpoint path

 The signals in the main setpoint path are limited to a value range of ±32767.
 The signal at nNSet_a is first led via the JOG selection function.
 A selected JOG value switches the nNSet_a input inactive. Then, the subsequent signal
conditioning operates with the JOG value.
820
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Possible settings
0.000 s
0.00 %
0.00 %
0.00 %
Bit 0 No blocking zone active
Bit 1 Blocking zone 1 active
Bit 2 Blocking zone 2 active
Bit 3 Blocking zone 3 active
Bit 4 Jog in blocking zone
Bit 5 MaxLimit active
Bit 6 MinLimit active
-199.99 %
-199.99 %
L
Info
999.900 Deceleration time T
if
additional setpoint
• Lenze setting: 0.000 s
100.00 Hysteresis window for zero detection
of speed output setpoint (output
bRfgIEqO)
• Lenze setting: 0.50 %
199.99 Maximum limit values for the speed
blocking zones
• Selection of the maximum limit
values for the blocking zones in
which the speed must not be
constant.
• Lenze setting: 0.00 %
199.99 Minimum limit values for the speed
blocking zones
• Selection of the minimum limit
values for the blocking zones in
which the speed must not be
constant.
• Lenze setting: 0.00 %
Status (bit-coded)
• Bits that are not listed are
reserved for future extensions.
199.99 nMaxLimit
• Maximum speed setpoint for
speed setpoint limitation
• Lenze setting: 199.99 %
199.99 nMinLimit
• Minimum speed setpoint for
speed setpoint limitation
• Lenze setting: -199.99 %
Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
for the