Ls_Pulsegenerator - Lenze 8400 StateLine C Reference Manual

8400 StateLine C | Reference manual
Function library
System blocks | LS_PulseGenerator
16.2.21

LS_PulseGenerator

This system block outputs 9 different fixed frequencies and 1 frequency with
parameterisable pulse/dead time.
From version
the first 1-ms processing cycle is complete and the time set in
status signal can e.g. be used for the delayed enable of peripheral devices or motor control
setpoints so that all required initial values are calculated first after the controller switch-
on.
Outputs
Identifier
b100Hz
b10Hz
b2Hz
b1Hz
b1HzFlash
b2HzFlash
bSingleFlash1
bSingleFlash2
bDoubleFlash
bSquareWave
bFirstCycleDone
(from version 06.00.00)
874
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
06.00.00, the SB provides a TRUE signal at the bFirstCycleDone output when
Value/meaning
Data type
Rectangular signal 100 Hz
BOOL
Rectangular signal 10 Hz
BOOL
Rectangular signal 2 Hz
BOOL
Rectangular signal 1 Hz
BOOL
80 ms-pulse, repetition rate every second
BOOL
80 ms-pulse, repetition rate every 0.5 seconds
BOOL
80 ms pulse, repetition rate every 1.25 seconds
BOOL
80 ms pulse, repetition rate every 2 seconds
BOOL
80 ms-double pulse, repetition rate every 1.25 seconds
BOOL
Output frequency with pulse/dead time set in
BOOL
Status signal "First processing cycle completed"
BOOL
TRUE The first 1-ms processing cycle has been completed and the time set
in
L
1C00400/3
C00400/1...2
C00400/3 has expired (i.e. all FBs have been called at least once).
Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
has expired. This