Changing The Parameterisation With The Keypad - Lenze 8400 StateLine C Reference Manual

8400 StateLine C | Reference manual
Introduction: Parameterising the controller
General notes on parameters
2.3.1

Changing the parameterisation with the keypad

Keypad display and control elements
LCD display
Headline
In the menu level: Menu name
In the parameter level: Parameter name
Three-part display
In the menu level: List of available menus
In the parameter level: Code/subcode and setting or actual value
Device status
Controller is switched on

Controller is enabled

Controller is inhibited

Quick stop is active

Current limit exceeded

Speed controller 1 in the limitation

34
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
The keypad is simply plugged on the
diagnostic interface X6 ("DIAG") at the front
of the standard device.
Plugging and unplugging the keypad is
possible during operation.
Pulse inhibit is active

System fault is active

"Fault" device status is active

Device status "Trouble" active

Device status "TroubleQSP" active

A warning is indicated

L
Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011