Save All Parameter Sets - Lenze 8400 StateLine C Reference Manual

4.1.3

Save all parameter sets

If parameter settings are changed in the controller, those changes will be lost after mains
switching of the controller unless the settings have been saved explicitly.
The C00002/11
safe against mains failure to the memory module of the controller.

Note!
When the device is switched on, all parameters are automatically loaded from
the memory module to the main memory of the controller.
Observe the following to avoid data inconsistencies which cause errors when the
parameters are loaded from the memory module:
During the storage process:
• Do not switch off the supply voltage!
• Do not remove the memory module from the device!
The controller is currently provided with one data record for all parameters, i.e.
every parameter has a value. Several data records per controller are in
preparation.

How to save the parameter settings to the memory module:
Execute the "Save all parameter sets" device command:
C00002/11
The storage process may take a couple of seconds. After the device command has
been called in C00002/11, dynamic status information ("Work in progress 20%" 
"Work in progress 40%"  "Work in progress 60%", etc.) is returned.

Tip!
• This device command can also be activated via the
• The
the parameter settings to the delivery status of the device.
Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
= "1: On / start" device command saves the current parameter settings
= "1: On / start"
"Load Lenze setting" device command
L
8400 StateLine C | Reference manual
Device commands (C00002/x)
Toolbar icon.
(C00002/1 = "1: On / start") resets
Device control (DCTRL)
81