Selection Of The Technology Application And The Control Mode - Lenze 8400 StateLine C Reference Manual

8400 StateLine C | Reference manual
Technology applications

Selection of the technology application and the control mode

7.1 Selection of the technology application and the control mode
Die Auswahl der zu verwendenden Technologieapplikation erfolgt in C00005.
 You can select the technology application in the »Engineer« on the Application
parameter tab via the Application list field:
Different control modes can be selected for every application in C00007. By selecting the
control mode you set the way by which the technology application should be controlled,
e.g. via terminals or via a fieldbus. The interconnection of the input/output terminals and
ports shown in the FB editor in the I/O level changes accordingly.
 You can select the control mode in the »Engineer« on the Application parameter tab via
the Control mode list field:

Tip!
You can infer the pre-configured assignment of the input/output terminals and
ports for each control mode from the description of the corresponding technology
application:
TA "Actuating drive speed":
TA "Switch-off positioning":
Detailed information on the individual configuration of the input/output
terminals can be found in the description of the I/O terminals in the subchapter
"User-defined terminal
290
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Terminal assignment of the control modes
Terminal assignment of the control modes
assignment".
( 282)
L
( 302)
( 329)
Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011