Switchedon - Lenze 8400 StateLine C Reference Manual

L-force drives; e84avsc series;

Hide thumbs Also See for 8400 StateLine C:

Table of Contents

8400 StateLine C | Reference manual

Device control (DCTRL)

Device state machine and device statuses

SwitchedOn

LED DRIVE READY

The drive is in this device status if the DC bus voltage is applied and the controller is still

inhibited by the user (controller inhibit).

 The bus systems are running and the terminals and encoders are evaluated.

 The monitoring modes are active.

 The application is basically executable.

If the controller inhibit is deactivated, the devices changes to the "OperationEnabled"

status and the motor follows the setpoint defined by the active application.

controller inhibit.

Depending on certain conditions, a status change takes place based on the "SwitchedOn"

device status:

Change condition

Control bit "EnableOperation" of all control channels = "1"

AND terminal RFR = HIGH level (controller enable)

Control bit "SwitchOn" of a control channel = "0".

Motor parameter identification requested.

Undervoltage in the DC bus.

Error with error response "Trouble" occurs.

Error with error response "TroubleQSP" occurs.

Table of Contents