Analog Signal Monitor - Lenze 8400 StateLine C Reference Manual

8400 StateLine C | Reference manual
Technology applications
"GeneralPurpose" functions
7.4.8

Analog signal monitor

This function serves to output four analog signals selected from a list of all analog output
signals available in the drive controller. Offset and gain of the source signals can be
adjusted.
[7-12] GeneralPurpose function "Analog signal monitor"
Parameter
C00410/1...4
C00413/1
C00413/2
C00413/3
C00413/4
C00413/5
C00413/6
C00413/7
C00413/8
 For a detailed functional description see the
7.4.9 D-FlipFlop
This function saves the logic status of the data input (1D) in case of an active clock edge at
the clock input (C1) and puts out its value in sequence at the output Q. If there is no active
clock edge, the input value is not accepted.
[7-13] GeneralPurpose function "D-FlipFlop" (clock-edge controlled)
 For a detailed functional description see FB L_DFlipFlop.
350
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
C00410/1
C00410/2
C00410/3
C00410/4
Info
L_SignalMonitor_a: Signal 1 ... 4
L_SignalMonitor_a: Signal 1 offset
L_SignalMonitor_a: Signal 1 gain
L_SignalMonitor_a: Signal 2 offset
L_SignalMonitor_a: Signal 2 gain
L_SignalMonitor_a: Signal 3 offset
L_SignalMonitor_a: Signal 3 gain
L_SignalMonitor_a: Signal 4 offset
L_SignalMonitor_a: Signal 4 gain
C00833/4
bGPDFlipFlop_InD
C00833/5
bGPDFlipFlop_InClk
C00833/6
bGPDFlipFlop_InClr
L
C00413/1 C00413/2
nGPSignalOut1_a
C00413/3 C00413/4
nGPSignalOut2_a
C00413/5 C00413/6
nGPSignalOut3_a
C00413/7 C00413/8
nGPSignalOut4_a
L_SignalMonitor_a
bGPDFlipFlopOut
1D Q
C1
bGPDFlipFlop_NegOut
R Q
Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
Lenze setting
Value Unit
0: Not connected
0.00 %
100.00 %
0.00 %
100.00 %
0.00 %
100.00 %
0.00 %
100.00 %
FB.