Basic Settings - Lenze 8400 StateLine C Reference Manual

5.7.3

Basic settings

The following "Initial commissioning steps" must be performed to commission the
sensorless vector control:
Initial commissioning steps
1. Determine the motor control:
C00006
2. Set the motor selection/motor data
• When selecting and parameterising the motor, the motor nameplate data and the equivalent circuit
diagram data are relevant. Detailed information can be found in the
chapter.
Depending on the motor manufacturer, proceed as follows:
Lenze motor:
Selecting a motor from the motor catalogue in the
»Engineer«
- or -
1. Set the motor nameplate data
2. Automatic motor data identification
3. Define the type of control:
bTorquemodeOn = FALSE:
bTorquemodeOn = TRUE:
4. Set the slip compensation (C00021).

Tip!
Information on the optimisation of the control mode and the adaptation to the
real application is provided in the chapter
We recommend to use the flying restart function for connecting/synchronising the
inverter to an already rotating drive system.
Parameterisable additional functions are described correspondingly in the chapter
"Parameterisable additional
Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
= "4: SLVC: Vector control"
( 107)
Speed control with torque limitation
Torque control with speed limitation
Slip compensation ( 207)
functions".
L
8400 StateLine C | Reference manual
Sensorless vector control (SLVC)
"Motor selection/Motor
Third party manufacturer's motor:
1. Set the motor nameplate data
2. Automatic motor data identification
equivalent circuit diagram data manually:
C00082: Motor rotor resistance
C00084: Motor stator resistance
C00085: Motor stator leakage inductance
C00092: Motor magnetising inductance
C00095: Motor magnetising current
"Optimising the control
Flying restart function
( 193)
Motor control (MCTRL)
data"
or set known
mode".
( 166)
( 200)
165