General Notes On Parameters - Lenze 8400 StateLine C Reference Manual

2.3

General notes on parameters

All parameters for controller parameterising or monitoring are saved as so-called "codes".
 The codes are numbered and indicated by the prefix "C" before the code, e.g. "C00002".
 Moreover, each code has a name and specific attributes, as for example access type
(reading, writing), data type, limit values and default setting ("Lenze setting").
 For the sake of clarity, some codes contain "subcodes" for saving parameters. This
Manual uses a slash "/" as a separator between code and subcode, e.g. C00118/3".
 According to their functionality, the parameters are divided into three groups:
– Setting parameters: For specifying setpoints and for setting device / monitoring
functions.
– Configuration parameters: For configuring signal connections and terminal
assignments.
– Diagnostic/display parameters: For displaying device-internal process factors,
current actual values and status messages. These parameters can only be read.
Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
8400 StateLine C | Reference manual
Introduction: Parameterising the controller
L
General notes on parameters
33