Led Status Displays Of The Device Status - Lenze 8400 StateLine C Reference Manual

8400 StateLine C | Reference manual
Diagnostics & error management
LED status displays
9.2.1

LED status displays of the device status

The control of the two LEDs "DRIVE READY" and "DRIVE ERROR" in the lower part on the
front of the controller depends on the device status.
statuses
( 86)
[9-2] DRIVE READY and DRIVE ERROR LED status displays
The meaning can be seen from the table below:
DRIVE READY
OFF
OFF
OFF
OFF
Legend
The symbols used for indicating the LED states have the following meaning:
382
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
DRIVE READY
DRIVE ERROR Description
OFF OFF or initialisation active
OFF Safe torque off is active
OFF Device is ready to start
OFF Device is switched on
OFF Motor data identification/operation
The controller is ready to switch on, switched
on or the operation is enabled and a warning
is indicated.
Fault active, quick stop
Trouble is active
Fault is active
System fault is active
LED is flashing once approx. every 3 seconds (slow flash)
LED is flashing once approx. every 1.25 seconds (flash)
LED is flashing twice approx. every 1.25 seconds (double flash)
LED is blinking every second
LED is permanently on
L
Device state machine and device
DRIVE ERROR
Device status
(Display in C00137)
Init
SafeTorqueOff
ReadyToSwitchOn
SwitchedOn
OperationEnabled
TroubleQSP
Trouble
Fault
SystemFault
Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011